Installation method for bathroom partitions:

1. Draw the midpoint line of the fastener on the wall, drill 3 holes on the electric drill line, insert the pre embedded plastic plug into the hole, and then use the Wall plug to fix the fastener on the wall.

2. The floor should draw the midpoint line of the foot seat position, and the foot seat should be adjusted and fixed on the floor 150mm away from the front edge of the partition.

3. Place the partition board against the wall mounting plate, adjust the foot pedal, and lift the board to the ground with a normal height of 145mm. After determining the level, fix the partition board with the screws on the wall mounting plate and adjust the foot pedal.

4. After the middle, fix the rod with screws and fix it on the top of the four middle columns as L fixed blades. The pipe and partition are fixed to the combined body wall pillar - draw a straight line perpendicular to the ground on the wall, use a drill bit to drill on line 3, insert plastic into the hole, confirm and vertical, and use L fixed screws to fix the wall column on the 145 high ground.

Terminal post - Fix the upper flange pull rod and L-shaped edge joint to the terminal post and screw the board to the cabinet board.

5. Cut and fix according to the actual length of the compartment. When the straight rod is flat, the pipe should be equipped with a circular joint sleeve and emergency spring plate to make the joint smooth and firm. For the 90 degree angle rod in the compartment, use an aluminum alloy injection molded 90 degree angle joint to connect the two ends of the angle rod. Use a convex circular wall to secure the sleeve, and use screws to secure the terminal rod to the wall. Use screws to connect the pull rod to the fixture on the upper edge of the chromatographic column.

6. Fix the hinge seat on the pillar, install the hinge plate on the door leaf from top to bottom, and automatically place the nylon seat on the hinge seat to enable the door leaf to automatically open and close at the desired angle.

When the security indicator lock is fixed on a column without users, it will display green and red when closed. In emergency situations, the safety indicator lock can be opened outside to facilitate the emergency needs of the safety indicator lock. When tightening the bathroom partition screws, first tighten the bottom screws and pay attention to the couplings on both sides of the baffle door. Do not shake the door to avoid damaging the partition.